In one of the workshop classes I learned two perspective drawings. I was given a picture connected to my project so I can practice on more convenient shape.
First I have to find the right horizontal level, I could use ruler and draw a lines or in this scenario as it was workshop, by an eye. So I draw it just below middle of the playhouse and draw two points on the opposite edges of that line. I measured th ratio between high and width and converted, so it fit to the page high.
After draw the playhouse with pencil and removing all supporting lines, then i went again with fine liner to give it that finished, sharp look. Only one major issue I had is that I didn't take enough pictures through the process.
Lukasz, this is a pretty poor effort, for someone going onto Product Design this should be a straightforward exercise. The photos are very low level. Scan your drawings.
ReplyDeleteThe drawing is too big to feet into the scanner.
Delete